Table of Contents
Advertisement
Chapter 1: Introduction
Tester Components
Controller
Carrying Handle: For carrying the Controller and Tester
Pod (when attached).
Controller Release Lever: Press to release the Controller
from the Tester Pod.
Power Button: Hold for 2 seconds to turn the Controller
on and off independent of the Tester Pod. Flashes when
the Controller is being charged.
Touch Screen: Primary user interface.
Camera & Flashlight: For VIN scanning and identification.
Temperature Sensor: For measuring battery temperature.
Micro-USB Port: For updating and servicing the Control-
ler when a WiFi network is not available.
Power Supply Connection
Tester Pod
Accessory Connector: For connecting an optional acces-
sory (ex. Amp Clamp / DMM Cable) to the Tester Pod.
Controller Charging Contacts: For charging and communi-
cating with the Controller when mounted to the Tester Pod.
Status Indicator LEDs:
- Power is on
- Tester Pod is communicating with the Controller
Clamp Storage Mounts: Use to keep the test clamps
protected when the tester is not in use.
Tester Pod Internal Batteries
Charging Dock
Tester Pod Charging Contacts: For charging the Tester Pod
Power Supply Connection
DSS-5000 HD
- Clamps reversed
Advertisement
Table of Contents
Need help?
Do you have a question about the DSS5000PHDKT and is the answer not in the manual?
Questions and answers