DSS-5000
IMPORTANT: Always place the DSS-5000 in the
plugged-in charging dock when not in use to allow
the tool to automatically check for and perform any
available software updates.
Controller
Carrying Handle: For carrying the Controller and Tester Pod
(when attached).
Controller Release Lever: Press to release the Controller
from the Tester Pod.
Power Button: Hold for 2 seconds to turn the Controller on
and off independent of the Tester Pod. Flashes when the
Controller is being charged.
Touch Screen: Primary user interface.
Camera & Flashlight: For VIN scanning and identification.
Temperature Sensor: For measuring battery temperature.
Micro-USB Port: For updating and servicing the Controller
when a WiFi network is not available.
Power Supply Connection
www.midtronics.com
Toyota/Lexus
DSS-5000
Tester Pod
Accessory Connector: For connecting an optional acces-
sory (ex. Amp Clamp / DMM Cable) to the Tester Pod.
Controller Charging Contacts: For charging and communi-
cating with the Controller when mounted to the Tester Pod.
Status Indicator LEDs:
- Power is on
- Tester Pod is communicating with the Controller
Integrated Printer: For printing and sharing test results.
Clamp Storage Mounts: Use to keep the test clamps pro-
tected when the tester is not in use.
Tester Pod Internal Batteries
Charging Dock
Tester Pod Charging Contacts: For charging the Tester Pod
Power Supply Connection
Midtronics Inc.
Quick Start Guide
Quick Start Guide
167-000868EN-B
167-000868EN-B
- Clamps reversed
7000 Monroe Street Willowbrook, IL 60527
Page
1
May 2020
May 2020