Supermicro SuperServer SYS-111E-FWTR-EU User Manual page 42

4. Press all four rotating wires outwards and make sure that the heatsink is securely
latched onto the CPU socket.
5. With a T30 bit torque driver set to a force of 8.0 in-lbf (0.904 N-m), gradually tighten the
four screws to ensure even pressure. You can start with any screw, but make sure to
tighten the screws in a diagonal pattern.
Note: Do not use a force greater than 8.0 in-lbf (0.904 N-m). Exceeding this force may over-
torque the screw, causing damage to the processor, heatsink, and screw.
6. Examine all corners of the heatsink to ensure that the PHM is firmly attached to the
CPU socket.
Chapter 3: Maintenance and Component Installation
8.0
IN-LBF
0.904
N-M
3 4
5 6 7 8 9 10 1 1
42