Acquiring/Releasing The User Interface; Acquiring The Active User Interface; Releasing The Active User Interface - Paradyne 3350 User Manual

ACCULINK 3350 E1 NTU
Acquiring/Releasing
the User Interface
You can access the user interface from either the front
panel or the COM port. The E1 NTU allows only one user
interface to be active at a time. The front panel is the
default user interface at power-up or after a reset. It is also
the default during a software download or when a failure
occurs at either the local or remote PC interface.
You can switch an inactive user interface to active if,
The current active user interface has had no activity
(no key was pressed) for at least five minutes,
and/or
The active user interface has been released with the
Release command.

Acquiring the Active User Interface

To acquire the active user interface, press any key. If
you are using the PC interface, use the mouse to click on
the desired Function key.
The top-level menu screen appears on the active user
interface, regardless of what screen was displayed at the
previous active user interface.
E1 HDSL NTU
Stat Test
F1 F2
The inactive interface displays the following message
when a Function key is pressed or a connection is made
on the inactive user interface and control cannot be
switched because the currently active interface is in use.
On the screen, either Ft. Panel (front panel) or COM Port
is displayed in the user interface (User I/F) field.
E1 HDSL NTU
User I/F active
F1 F2
3-18
Cnfig
F3
F3
June 1996
The inactive interface displays the following message
after control has been released from the previously active
interface and another interface has not become active.
E1 HDSL NTU
User I/F idle
F1 F2

Releasing the Active User Interface

To release the current active user interface, either allow
five minutes to elapse without pressing any key or use the
Release command.
To use the Release command,
1. From the top-level menu screen, press the
until the Ctrl selection appears on the screen.
E1 HDSL NTU
Stat
F1
2. Select Ctrl.
E1 HDSL NTU
Test
F1
3. From the Control screen, select Rel (Release).
Control:
Rel
F1
F3
key
Test Cnfig
F2 F3
Cnfig Ctrl
F2 F3
ClrReg
F3
F2
3350-A2-GB20-10