Paradyne 3350 User Manual page 97

dsx1RcvFarEndLOMF(512) – The far end is
sending a Loss of MultiFrame Failure (RMA).
dsx1XmtFarEndLOMF(1024) – The near end is
sending a Loss of MultiFrame Failure (MFA).
dsx1Other Failure(4096) – An Excessive Error Rate
(EER) has been detected on the network interface.
Near End Group – "dsx1SignalMode" Object
(dsx1ConfigEntry 11)
This object is not supported by the 3350 NTU.
Near End Group – "dsx1TransmitClockSource"
Object (dsx1ConfigEntry 12)
This object is not supported by the 3350 NTU.
Near End Group – "dsx1Fdl" Object
(dsx1ConfigEntry 13)
This object specifies how Facility Data Link is being
used. Only the following values are supported by the E1
NTU. More than one value may be active at a time.
dsx1other(1) – SNMP data is being sent over FDL.
dsx1Fdl-none(8) – Indicates that the device does
not use FDL. This value is always returned for the
G.703 DTE interface. It is also returned for the
network interface when the FDL management link
is disabled.
Near End Group – The DS1 Current Table
Objects (dsx1CurrentEntry)
The following DS1 current table objects are provided
for the network interface only. Objects in the table that are
not listed are not supported and will return an error status
if access is attempted.
dsx1CurrentIndex – The index that identifies the E1
interface.
dsx1CurrentESs – Errored Seconds for the current
interval.
dsx1Current SESs – Severely Errored Seconds for
the current interval.
dsx1CurrentUASs – Unavailable Seconds for the
current interval.
3350-A2-GB20-10
dsx1CurrentBESs – Bursty Errored Seconds for the
current interval.
Near End Group – The DS1 Interval Table
Objects (dsx1IntervalEntry)
The following DS1 interval table objects are provided
for the network interface only. Objects in the table that are
not listed are not supported and will return an error status
if access is attempted.
dsx1IntervalIndex – The index that identifies the E1
interface.
dsx1IntervalNumber – The interval number
(1 to 96).
dsx1IntervalESs – Errored Seconds for the interval.
dsx1Interval SESs – Severely Errored Seconds for
the interval.
dsx1IntervalUASs – Unavailable Seconds for the
interval.
dsx1Interval BESs – Bursty Errored Seconds for
the interval.
Near End Group – The DS1 Total Table Objects
(dsx1TotalEntry)
The following DS1 total table objects are provided for
the network interface only. Objects in the table that are not
listed are not supported and will return an error status if
access is attempted.
dsx1TotalIndex – The index that identifies the E1
interface.
dsx1TotalESs – The 24-hour total Errored Seconds.
dsx1Total SESs – The 24-hour total Severely
Errored Seconds.
dsx1TotalUASs – The 24-hour total Unavailable
Seconds.
dsx1TotalBESs – The 24-hour total Bursty Errored
Seconds.
June 1996
SNMP MIB Objects
E-9