Paradyne 3350 User Manual page 80

ACCULINK 3350 E1 NTU
Entp Trap: Enab
Next Enab Disab Prev
Enterprise Specific Traps. Specifies whether enterpriseSpecific traps are enabled. For more information, refer to the
SNMP Traps section in Chapter 4, Maintenance .
Enab – Sends trap messages for enterpriseSpecific events to the currently configured trap manager(s).
Disab – Disables the sending of trap messages for enterpriseSpecific events.
NOTE: This configuration option is not available if the SNMP Trap configuration option (in the Alarm Configuration
Options section) is disabled.
Link Trap: Both
Next Disab Up Down
Link Trap Type. Specifies the link trap type to enable. Interfaces monitored for linkUp and linkDown traps are specified
with the Trap I/F configuration option. For more information, refer to the SNMP Traps section in Chapter 4, Maintenance .
Disab – Disables the sending of trap messages for linkDown or linkUp events.
Up – Sends trap messages for linkUp events to the currently configured trap manager(s).
Down – Sends trap messages for linkDown events to the currently configured trap manager(s).
Both – Sends trap messages for linkUp and linkDown events to the currently configured trap manager(s).
NOTE: This configuration option is not available if the SNMP Trap configuration option (in the Alarm Configuration
Options section) is disabled.
Trap I/F: E1s
Next NET DTE E1s
Link Trap Interfaces. Specifies which interfaces generate linkUp and linkDown trap messages. These traps are supported
on the E1 interfaces (network and G.703 DTE).
NET – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the
network interface.
DTE – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the
G.703 DTE interface. This selection is not displayed if the G.703 DTE interface is disabled.
E1s – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on either
the network or G.703 DTE interface.
NOTE: This configuration option is not available if the Link Trap configuration option is not configured to generate trap
messages for linkUp or linkDown events.
C-14
Table C-7
(2 of 2)
SNMP Trap Configuration Options
Both Prev
Prev
June 1996 3350-A2-GB20-10