Network Interface Options Menu - Paradyne 7520 Technical Manual

Network Interface Options Menu

10
For Network Interface Options, refer to Table 2. To access the Network Interface
Options screen, follow this menu selection sequence:
Main Menu Configuration (Load Configuration From)
Configuration Edit/Display
Table 2. Network Interface Options
Network-initiated DSU Loopback (64K CC)
Possible Settings: Enable, Disable
Default Setting: Enable
Indicates whether the access unit responds to a DSU latching loopback sequence sent
by the network as specified by TR62310.
H
Network-initiated DSU Loopback (64K CC) option appears when
is set to DDS (see Table 1, System Options).
Enable – Responds to network-initiated commands to start and stop a latching DSU
loopback.
Disable – DSU will not respond to a DSU loopback initiated by the network.
Data Scrambling (64K CC)
Possible Settings: Enable, Disable
Default Setting: Disable
Determines whether data scrambling is used to suppress the possible simulation of
network-initiated DSU latching loopback commands by application data.
H
Data Scrambling (64K CC) option appears when
(see Table 1, System Options).
Enable – Enables data scrambling. The local and remote units must be set the same.
Disable – No data scrambling.
V.54 Initiated DSU Loopback
Possible Settings: Enable, Disable
Default Setting: Enable
When enabled, user data is looped back to the network when a V.54 Loop Up sequence
is received. The DSU loopback ends when a V.54 Loop Down sequence is detected.
Enable – DSU loopback can be initiated or terminated by a remote unit sending in-band
V.54 Loop 2 Up or Down sequences.
Disable – V.54 Loop 2 sequences are ignored.
December 1998
Network
Operating Mode
Operating Mode
is set to DDS
7520-A2-GN10-10