Paradyne 3350 User Manual page 95

IP Group – "ipRouteAge" Object
(ipRouteEntry 10)
This object is implemented as a read-only object in the
E1 NTU. In the E1 NTU, it reflects the value of the
route's time-to-live (in seconds). When displayed, a value
of 999 represents a route that is retained permanently. For
temporary routes, the ipRouteAge object decrements over
time. All routes added via an SNMP set of the
ipRouteTable are considered permanent routes. These
routes do not age, but will remain unless deleted via
SNMP.
ICMP Group, MIB II
The ICMP Group objects are fully supported by the E1
NTU.
UDP Group, MIB II
The User Datagram Protocol (UDP) Group objects are
fully supported by the E1 NTU.
Transmission Group, MIB II
Objects in the transmission group are supported on the
network and G.703 DTE interfaces, the COM port, and
the AUX port. The objects in the transmission group are
not defined within MIB II, but rather through other
Internet standard MIB definitions. The following two
transmission group objects are supported by the E1 NTU.
ds1 (transmission 18) – The transmission object
supported on the E1 interfaces.
rs232 (transmission 33) – The transmission object
supported on the COM port and the AUX port.
The "ds1" transmission object is defined by the
DS1/E1 MIB. The rs232 transmission object is defined by
the RS-232-like MIB.
3350-A2-GB20-10
SNMP Group, MIB II
The SNMP Group objects that apply to a management
agent are fully supported by the E1 NTU. The following
objects apply only to an NMS and return a zero value if
accessed.
snmpInTooBigs (snmp 8)
snmpInNoSuchNames (snmp 9)
snmpInBadValues (snmp 10)
snmpInReadOnlys (snmp 11)
snmpInGenErrs (snmp 12)
snmpInGetResponses (snmp 18)
snmpInTraps (snmp19)
snmpOutGetRequests (snmp 25)
snmpOutGetNexts (snmp 26)
snmpOutSetRequests (snmp 27)
snmpOutGetResponses (snmp 28)
DS1/E1 MIB (RFC 1406)
The "ds1" object defined by RFC 1406 is supported for
both the network and G.703 DTE interfaces. The DS1
Near End Group and DS1 Fractional Group are supported
for both interfaces. The DS1 Far End Group is not
supported.
Near End Group, DS1/E1 MIB
The DS1 Near End Group consists of the following
four tables:
DS1 Configuration
DS1 Current
DS1 Interval
DS1 Total
All four tables are fully supported for the network
interface. Since statistics are not kept for the G.703 DTE
interface, only the DS1 Configuration table is fully
supported. The "statistic" objects for the G.703 DTE
interface entry in the DS1 Current, DS1 Interval, and DS1
Total tables are always zero (null). The following sections
provide clarification for objects contained in the Near End
Group when it is not clear how the object definition in the
DS1/E1 MIB is related to the E1 NTU.
June 1996
SNMP MIB Objects
E-7