Setting Customer Identification; Displaying Led Conditions - Paradyne 3163 User Manual

ACCULINK 3163 DSU/CSU
Setting Customer
Identification
The customer identification is the only identity number
you can change. It is used to uniquely identify the
DSU/CSU.
"
Procedure
To change the customer identification (CID):
1. From the top-level menu, press the
the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, press the
the CID selection appears on the screen.
4. Select CID.
Control:
Reset
F1
5. Use the and
under the desired character. You must enter a
character before the
next space to the right.
CustID: xxxxxxxx
Up
F1
6. Enter the desired ID. Press F1 (Up) and F2
(Down) to scroll up and down through the valid
characters/numbers for the customer ID. Valid
characters are 0 through 9, #, -, ., /, A to Z, and
blank space. Press F3 (Save) to save the ID.
3-8
key until
key until
CID Passwd
F3
F2
keys to position the cursor
moves the cursor to the
Down Save
F3
F2

Displaying LED Conditions

The same conditions monitored by the front panel
LEDs can also be monitored by the LED command. This
command is most useful when the DSU/CSU is being
accessed remotely (see Appendix F,
Emulation). When using Front Panel Emulation, no LEDs
are shown on the PC's screen; you must use the Stat
command procedure described below to get LED
information.
The following procedure is an
example only. Screen displays
may vary depending on the
model of the DSU/CSU.
"
Procedure
To display LED conditions on the front panel screen:
1. From the top-level menu screen, select Stat.
2. From the Status screen, press the
LED selection appears on the screen.
3. From the Status screen, select LED.
March 1999
Front Panel
NOTE
key until the
Status:
Perf TStat LED
F3
F1 F2
3163-A2-GB20-10