Knife Replacement - Band-it IT7000 User Manual

User Manual

KNIFE REPLACEMENT

Remove the Head Cover (1). Pinch the front of cover and rotate down to remove. Remove the E-Clips (2) on the
non-motor side only. Push the 2 pins (3) down far enough to allow the linkage (4) to swing out. Remove the
knife (5).
Apply a film of grease to the new knife and pins and reassemble, using new E-clips if needed.
Replacement Knife Kit Part Number:
Note: The cutter knife has only one
cutting edge. This edge must be properly
oriented as shown when installing.
Important:
Prior to any maintenance or disassembly,
be sure to disconnect all power sources
to the tool and discharge pressurized air
from the air system.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Tool
Part Number
1
Cutting
Edge
IT8000 IT7000
H80935 H70935
Figure 78
4
Figure 79
46
IT8000 3/8" TIE-LOK DATA TOOL
IT7000 1/4" TIE-LOK DATA TOOL
ITC800 CONTROL SYSTEM
3
5
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
2