Table of Contents
Advertisement
User Manual
MAINTENANCE
MAINTENANCE SCHEDULE
The IT8000/IT7000 tool requires periodic maintenance to prevent malfunction or damage. Refer to the table
below for recommended maintenance intervals of critical tool components. Intervals may vary depending on the
operating environment.
Table 6
Components
Backing Wheel
Tension Wheel
Punch
Knife
Head Assembly
To maximize performance and extend tool life:
•
Do not use degreaser on any part of the tool.
•
Do not spray any lubricant or cleaner into the pneumatic system.
•
Do not remove factory-applied lubrication from inside tool unless performing a thorough maintenance
procedure and then replacing with clean lubricant immediately.
•
Follow preventative maintenance and parts replacement instructions at appropriate service intervals.
•
For maintenance beyond what is described in this manual, contact BAND-IT.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Recommended
Service
Grease pin
Inspect and replace if
worn
Clean with wire brush
(included w/ tool)
McMaster PN:7092T18
Inspect and replace if
worn
Inspect and replace if
worn
Grease
McMaster PN: 1208K22
Inspect and replace if
worn
Inspect and replace if
worn
43
Recommended Interval
Every 20,000 clamps
100,000 clamps
Every 20,000 clamps
50,000 clamps
100,000 clamps
Every 20,000 clamps
50,000 clamps
100,000 clamps
IT8000 3/8" TIE-LOK DATA TOOL
IT7000 1/4" TIE-LOK DATA TOOL
ITC800 CONTROL SYSTEM
Page Ref.
44
49
45
49
48
44
46
47
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
Advertisement
Table of Contents
