Table of Contents
Advertisement
User Manual
HEAD REPLACEMENT
Remove the Head Cover (1). Remove the E-Clips 2x (2) on the motor side only. Pull the pins 2x (3) out of the
head. Swing the Linkages (4) down to access the head bolts. Remove the bolts (7/64" hex key) 4x (5). Disconnect
the sensor cable and remove the head (6).
Apply a film of grease on the pins and knife and reassemble. Ensure that the upper pin goes through the trigger
assembly linkage (7) (Fig. 81). Apply Blue Loctite to screws. Only pull-on gray cable jacket when connecting head
sensor.
The pneumatics cover or side cover may need to be removed to reconnect the head sensors or to insert the
pins.
Replacement Head Kit Part Number:
Part Number
7
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Tool
H80945 or H80940 (no sensors)
2
6
Figure 81
IT8000
H70945 or H70940 (no sensors)
5
Figure 80
47
IT8000 3/8" TIE-LOK DATA TOOL
IT7000 1/4" TIE-LOK DATA TOOL
ITC800 CONTROL SYSTEM
IT7000
3
4
Important:
Prior to any maintenance or disassembly,
be sure to disconnect all power sources to
the tool and discharge pressurized air from
the air system.
Document # P80080 Rev. C.3
1
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
Advertisement
Table of Contents
