Table of Contents
Advertisement
User Manual
TENSION WHEEL REPLACEMENT
Remove the Side Cover (1). Remove the screws (9/64 hex key) 8x (2). Remove the clevis pin (3) and drop the
pinch arms (4).
Remove retaining ring (5). Remove ball bearing (6). Remove gripper wheel (7). A small pry bar may be required
to break the gripper free from the gearbox shaft. This will also break the bearing free from the frame.
Reassemble, apply grease to inner diameter of gripper and align keyed slot of gear box shaft to gripper.
Replacement Tension Kit Part Number:
1
2
Figure 83
Important:
Prior to any maintenance or disassembly,
be sure to disconnect all power sources to
the tool and discharge pressurized air from
the air system.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Tool
Part Number
3
4
IT8000
IT7000
H80915
4
Figure 84
49
IT8000 3/8" TIE-LOK DATA TOOL
IT7000 1/4" TIE-LOK DATA TOOL
ITC800 CONTROL SYSTEM
7
5
6
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
Advertisement
Table of Contents
