Tension Wheel Cleaning - Band-it IT7000 User Manual

User Manual

TENSION WHEEL CLEANING

1. Remove the clevis pin (1) holding the pinch arms (2) and allow it to swing down. Be careful to ensure the backing
wheel and pin do not slide out with the pinch arms removed.
2. Enter manual mode to drive the tension wheel for a few revolutions with the wire brush (1/4" brush width) (3)
pressed firmly up into the rotating wheel.
3. During reassembly, re-center the tension wheel between the pinch arms and the band guide lined up on the
pinch arms to allow for proper re-assembly.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
3
2
Figure 77
45
IT8000 3/8" TIE-LOK DATA TOOL
IT7000 1/4" TIE-LOK DATA TOOL
ITC800 CONTROL SYSTEM
1
Important:
Prior to any maintenance or disassembly,
be sure to disconnect all power sources to
the tool and discharge pressurized air from
the air system.
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved