Harness Routing - Band-it IT7000 User Manual

User Manual
For applications where roll is not required, a bracket with Pitch and Yaw control can be used (Figure 53).
Note that the center of gravity is behind the hanger bracket. For best performance, the pivot point should be
located on the CG, not directly on the hanger bracket.
Pitch Axis

HARNESS ROUTING

It is recommended to run the pneumatic/electrical harness down the length of the articulating arm. This will
keep the harness out of the way and protect it from being damaged. Ensure that there is enough slack in the
harness to not bind as you maneuver the tool.
Note: the harness will stick approximately 2" (51 mm) behind the tool if the harness is routed as shown
below.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
Figure 53
Yaw Axis
Figure 54
29
IT8000 3/8" TIE-LOK DATA TOOL
IT7000 1/4" TIE-LOK DATA TOOL
ITC800 CONTROL SYSTEM
[57.4]
Figure 52
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved