Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Turn stand upside down and place top on flat
surface.
2.
Attach foot pedal caster assembly to side of
mobile base chassis with leveling feet, using
(2)
⁄
"-16 x 2
⁄
" hex bolts, (4)
3
1
8
2
(2)
⁄
"-16 hex nuts, and (1)
3
8
" flat washer (see Figure 9).
bolt and (1)
⁄
5
16
(Interior View)
Figure 9. Pedal assembly attached to right side
of stand.
3.
Place stand in upright position and adjust lev-
eling feet as needed with hex nuts so stand
rests level and stable on floor.
4.
Remove rear panel to access mounting holes
in stand during next step.
Model G0526A40 (Mfd. Since 12/22)
⁄
" flat washers,
3
8
⁄
"-18 x 2" hex
5
16
x 2
5.
With help from another person, place jointer
assembly onto stand. Attach assembly to
stand with (3)
⁄
"-16 x
3
8
lock washers (see Figure 10).
Note: Reach through dust chute to install fas-
teners on left side of stand. Ensure cutterhead
pulley is positioned above slot in stand.
x 3
Figure 10. Example of jointer assembly attached
to stand.
6. Place straightedge against pulleys to check
their alignment (see Figures 11–12).
— If pulleys are aligned, go to Step 8.
— If pulleys are not aligned, go to Step 7.
Straightedge
Figure 11. Example of checking pulley
alignment.
Cutterhead
Motor
Figure 12. Pulleys correctly aligned.
⁄
" hex bolts and
3
3
4
Slot
Touching
Evenly
-17-
⁄
"
8
Advertisement
Table of Contents
