Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
With help of assistant, lay sheet of cardboard
1.
on floor to protect media blasting cabinet, and
place cabinet on its back.
Using #2 Phillips screwdriver, fasten (4)
2.
legs to underside of cabinet with (16) M6-1
x 12 cabinet screws and flange nuts (see
Figure 6).
Attach (2) side supports (see Figure 6) to left
3.
and right set of legs with (4) M6-1 x 12 cabi-
net screws and flange nuts.
Figure 6. Leg installation.
With help of assistant, stand blast cabinet up
4.
on legs.
Remove the lamp box from inside of the
5.
cabinet, place the glass and the lamp box
onto the top of the cabinet, and fasten them
to the cabinet with the (6) M6-1 x 12 cabinet
screws.
-16-
Fasten the pressure gauge and regulator "L"
6.
bracket (see Figure 7) to the left front leg
using (2) cabinet screws and flange nuts.
Using (3) Phillips screws and flange nuts,
7.
fasten the hopper valve and chute door to
the hopper, as shown in (Figure 8). When
secured, latch the hopper door closed.
Side
Figure 8. Hopper valve and chute door.
Support
Using a Phillips screwdriver, remove the suc-
8.
tion port baffle (see Figure 9).
Figure 7. Regulator assembly.
Figure 9. Suction port baffle.
Model G0708 (Mfd. Since 12/23)
Advertisement
Table of Contents
