Assembly - Grizzly T33926 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Tip: We recommend using a set of C-clamps to
temporarily secure the base while assembling the
power feeder to prevent it from tipping. You will
mount the power feeder to the machine table after
completing the assembly process. Refer to Base
Mounting on Page 17 for specific details.
To assemble machine:
Place vertical column assembly onto machine
1.
table top, then attach vertical travel crank
handle to vertical crank shown in Figure 8.
Vertical
Travel
Crank
Handle
Figure 8. Vertical travel crank handle installed.
Loosen hex nut and set screw under hori-
2.
zontal handwheel shown in Figure 9, then
remove horizontal handwheel.
Feed overarm shaft into sleeve of vertical
3.
column (see Figure 9). Re-install handwheel
and engage gears with overarm shaft teeth.
Tighten set screw and hex nut just enough to
secure handwheel.
Note: Do not overtighten set screw or hand-
wheel will not rotate.
Model T33926 (Mfd. Since 08/23)
Vertical Crank
Horizontal
Handwheel
Figure 9. Overarm shaft installed onto vertical
column.
Slide angle adjustment scale onto overarm
4.
shaft, slide upper elbow-joint onto overarm
shaft, then secure for now by tightening one
of the hex bolts shown in Figure 10.
Angle
Adjustment
Scale
Figure 10. Angle adjustment scale installed onto
upper elbow-joint.
Attach rotation knob to power feeder
5.
(see Figure 11) using pre-installed cap
screw, flange nut, and (2) flat washers.
Figure 11. Rotation knob installed.
Overarm
Sleeve
Shaft
x 2
Upper Elbow-
Joint
Rotation
Knob
-15-