Nice Yubii Home Pro YHP-001 Instructions And Warnings For Installation And Use page 34

44
SCENARIOS - AUTOMATION
44.1 What are Scenarios ?
You can set up Scenarios. These are special scenes that allow you to control your roller shutters in the morning and in the evening.
The available scenarios:
• Morning scenario – the possibility to set the roller shutters to raise, lower or move to a favourite position at sunrise or at a specific time.
• Evening scenario – the roller shutters can be set to raise, lower or move to your favourite position at sunset or at a specific time.
A list of scenarios is available during adding a scene.
44.2 - Adding a Scenario
1. Open the Configuration Interface.
2. Go to Settings > Scenes
3. Click Scenario.
4. Select the Morning Scenario
5. Configure the actions to be performed.
6. The list of available Scenarios will be available on the Scenarios tab.
44.3 - Favourite roller shutter positions
During scenario creation, you can use your favourite roller shutter positions.
Note.
•
Intermediate position - comfortable opening, providing shade from the sun while keeping out the light in the room.
• Unsealed position (Ventilation) - minimum opening, providing security while keeping the outside air flowing in.
44.4 - Adding favourites for Elero
1. Open the Configuration interface.
2. Go to Settings > Devices.
3. Select the Elero device.
4. Open the device properties and select Advanced.
5. To start the process, click Configure.
6. The roller shutter opens (Intermediate) / closes (Ventilation) completely.
7. Press Start to start the process of lowering/raising the roller shutter, when it is in position click again to stop it.
8. Confirm the position.
9. If the roller shutter has not reached the desired level, you can repeat the configuration by clicking Configure again.
44.5 - Adding favourites for Nice and Z-Wave
1. Open the Configuration interface.
2. Go to
Settings > Devices.
3. Open the device properties and select Advanced.
4. To start the process, click Configure.
5. The controls for configuration (up, down, stop) will appear.
6. Adjust the correct position and then click Save this position.
7. If the roller shutter has not reached the desired level, you can repeat the configuration by clicking Configure again.
> Add Scene.
or the Evening Scenario.
34