Table of Contents
Advertisement
23
SPRINKLERS
If you don't have dedicated watering devices that support Z-Wave or other wireless technology,
you can create Sprinklers using Linked Devices.
To create a Sprinkle you need a watering device, for example, a switch connected to a solenoid valve.
Optionally, you can add a soil moisture sensor, which will stop watering whenever the set humidity level is reached.
Once you set your Linked Device, you have to configure the watering schedule in the Garden panel.
You can read more about it in the Garden Care section.
23.1 - Creating Sprinklers
1. Open the Configuration interface.
2. Go to
> Devices.
3. Click on
4. Select Nice Device.
5. Select Sprinklers.
6. Enter the name of the thermostat.
7. Choose a Room.
8. Choose watering devices.
9. Select soil moisture sensor (optional).
10. Set default watering time.
11. Set humidity level to turn off watering.
12. Save.
24
BINARY SENSORS
You can combine multiple binary sensors of the same type to create one main sensor. It will calculate its value from the values of the linked
devices using the logical operator you choose.
Available operators:
• AND
• OR
24.1 - Creating Binary sensors
1. Open the Configuration interface.
2. Go to
> Devices.
3. Click on
4. Choose Other Device.
5. Choose Binary Sensor.
6. Enter the name.
7. Choose a Room.
8. Choose Sensor Type.
9. Choose sensors that should be linked.
10. Choose which operator should be used to calculate the value.
11. Save.
21
Advertisement
Table of Contents
