Table of Contents
Advertisement
26
CAMERAS
Supported cameras: You can combine multiple binary sensors of the same type to create one main sensor. It will calculate its value from
the values of the linked devices using the logical operator you choose.
Note.
The following camera and gateway integration works with the 5.141.62 version and above.
26.1 - Adding Cameras to the Gateway
1. Log on to your gateway.
2. Click on Settings.
3. Click
Add
device.
4. Click
Other
device.
5. From the devices list find - Camera Nice.
6. Click Add.
7. Click Advanced.
8. Click
Add
Camera.
9. Click Advanced.
10. Enter the camera login.
11. Enter the camera password.
12. Enter the camera serial number.
You can obtain the camera serial number from the ConfigTool software - in the Modify IP section, click on Details.
13. Copy the serial number.
14. Paste the serial number.
15. Obtain the IP number from the ConfigTool software - in the Modify IP section.
16. Click Save.
17. Three endpoints will occur.
18. Each endpoint can be used in scene making.
26.2 - First start of the camera using ethernet cable
1. Connect your router with the camera, using LAN cable.
2. Connect the camera to the power supply (the power adapter should be included in your camera set).
3. Run the ConfigTool software.
4. Click
refresh.
3. Check the checkbox with the camera you want to start up
5. Click initialize.
6. Enter new password for the camera.
7. Confirm the new password.
8. Enter your e-mail address in case of loosing the camera password
9. Click Next.
10. Click OK.
11. Click Finish.
13. Click
Web
in the Modify IP section.
14. Enter the camera password.
15. Click Login.
26.3 - First start of the camera using Wi-Fi
1. Connect your router with the camera, using LAN cable.
2. Connect the camera to the power supply (the power adapter should be included in your camera set).
3. Run the ConfigTool software.
4. Click
refresh.
3. Check the checkbox with the camera you want to start up
5. Click initialize.
6. Enter new password for the camera.
7. Confirm the new password.
8. Enter your e-mail address in case of loosing the camera password.
9. Click Next.
10. Click OK.
11. Click Finish.
13. Click
Web
in the Modify IP section.
14. Enter the camera password.
15. Click Login.
16. Click Setting.
17. Click Network.
18. Click
and find your Wi-Fi network.
WiFi
19. Enter your Wi-Fi password.
20. Click Connection.
21. Correct connection will be confirmed with a "Connected" notification.
22. Camera is configured, click Logout.
23. Disconnect the LAN cable from the camera.
23
Advertisement
Table of Contents
