Table of Contents
Advertisement
12
ZIGBEE AND ELERO DEVICES
12.1 - Zigbee devices
Click
HERE
to learn more about operating Zigbee devices
12.2 - Elero devices
The gateway enables control of Elero devices with support for the PLN2 bidirectional communication protocol.
1. Open the Configuration interface.
2. Go to
> Devices .
3. Click on
4. Select the Elero device.
5. To complete the device pairing process, play the device state change at least 3 times using the keyboard buttons
or buttons in the interface.
6. Click the
Blind
button to start.
7. Follow the instructions shown on the screen.
8. When the pairing process is complete, the devices will be visible in
Note.
Synchronised pairing is possible. This allows multiple devices to be paired with the controller or remote at the same time.
The number of paired devices will be displayed during pairing. Synchronised pairing of Elero devices is available in the Nice/Elero settings.
13
Z-WAVE DEVICES
13.1 - Adding Z-Wave devices
1. Open the Configuration interface.
2. Go to
> Devices .
3. Click on
4. Select Z-Wave Device.
5. Set learning mode duration and click
6. Follow instructions of the device.
There are a few adding options you can choose in the
• Device is located far from the gateway (disable it for more security),
• NWI – Network-Wide inclusion (useful for devices that are not near the gateway, but withing networks range),
• Add in security mode if device supports it.
You can also set Learning mode duration – how much time you will have to perform the adding procedure on the
device.
13.2 - Removing Z-Wave devices (If not added)
1. Open the Configuration interface.
2. Go to
> Devices .
3. Click on the Z-Wave tab.
4. Click
5. Follow instructions of the device.
13.3 - Removing Z-Wave devices (If added)
1. Open the Configuration interface.
2. Go to
> Devices .
3. Click
next to the device you want to remove from the system.
4. Set learning mode duration and click Continue.
5. Follow instructions of the device.
13.4 - Force removing Z-Wave devices
1. Open the Configuration interface.
2. Go to
> Devices .
3. Click
next to the device you want to remove from the system.
4. Set learning mode duration and click Continue.
5. Click
which appeared in place of
6. Confirm the action.
7. The gateway will try to communicate with the device. If the device responds, the process will by canceled,
otherwise it will be removed from the system.
Start adding
window:
Add Device
.
Devices > Elero
and
15
Advertisement
Table of Contents
