Table of Contents
Advertisement
Stellar S-1200 Snow Machine
Cleaning the Fluid Pipes
The device must be cleaned periodically from the snow fluid residues. After every 40 hours of continuous
operation, it is recommended to run a cleaning solution composed of 80 % distilled water and 20 % white
vinegar through the system.
To clean the device, follow the steps below:
Disconnect the device from the electrical power supply.
Allow the device to cool down for at least 1 hour.
Clean out debris with vinegar and a pipe cleaner, making sure that the snow output nozzle (03) is
free of clogs.
Remove all snow liquid from the tank. See 6.4. Emptying the Tank after operation on page 24 for
more information.
Add a cleaning solution to tank.
Connect the power cable before supplying power to the device. See 4.5. Connecting to Power
Supply on page 17 for more information.
Make sure that you run the device until tank is empty.
Make sure that you use the device in spaces that have good airflow.
Repeat this 2-4 times.
Refill with snow liquid.
Corrective Maintenance
The device does not contain user-serviceable parts. Do not open the device and do not modify the
device.
Refer repairs and servicing to instructed or skilled persons. Contact your Highlite International dealer for
more information.
Replacing the Fuse
DANGER
Electric shock caused by short-circuit
●
Do not bypass the thermostatic switch or fuses.
●
For replacement use fuses of the same type and rating only.
Power surges, short-circuit or incorrect electrical power supply may cause a fuse to burn out. If the fuse
burns out, the device will not function anymore. If this happens, follow the steps below.
Disconnect the device from the electrical power supply.
02) Allow the device to cool down for at least 15 minutes.
03) Loosen the fuse cover with a screwdriver and remove the fuse holder.
04) If the fuse is brown or unclear, it is burned out. Remove the old fuse.
05) Insert a new fuse in the fuse holder. Make sure that the type and the rating of the replacement fuse
are the same as the ones specified on the information label of the product.
06) Replace the fuse holder in the opening and tighten the fuse cover.
Product code: 61115
34
Advertisement
Table of Contents
