Manual Mode; Dmx Operation - SHOWTEC Stellar S-1200 User Manual

Stellar S-1200 Snow Machine

Manual Mode

Set the snow output volume. See 6.7.4.2. Output Volume on page 27 for more information.
Set the wind speed. See 6.7.4.3. Wind Speed on page 27 for more information.
Press the MENU button, until the display shows: MSG RUN F100.
When the device is blowing snow, press the UP/DOWN buttons to change the H (WIND 50%) from 1–
100, and press START / PAUSE button for 2 seconds to change to F (WIND 100%) and use the
UP/DOWN buttons to change the F value from 1–100.
When you press the START / PAUSE button during the manual control mode, the display shows STP
and the device will stop blowing snow, but the fan will spin another 2–3 seconds.
To deactivate the STP function, press the START / PAUSE button.

DMX Operation

To setup up the device, follow the steps below:
Fill the tank (Fluid Tank Capacity 5 L). See 6.3. Filling the Tank on pages 21–23 for more information.
Connect the DMX cables before supplying power to the device. See 5.3. DMX Connection on page
17 for more information
Connect the power cable before supplying power to the device. See 4.5. Connecting to Power
Supply on page 16 for more information.
Set the ON/OFF switch (18) to ON.
Set the DMX starting address of the device in Address menu. See 5.3.4. DMX Addressing on page 19
and 6.7.4.5. DMX Address on page 30.
Note:
● Manual operation with the control panel on the device always has priority over the remote control.
Product code: 61115
30