Setup Variants - Fronius LaserHybrid WF 25i Operating Instructions Manual

Setup Variants

Power Source Located in Welding Cell (I)
-
-
-
-
-
-
-
-
-
Area of application:
The robot only makes minor compensatory movements.
Robot axles 7 and 8 carry out the majority of the welding feed movements.
Example:
Circumferential welds on boilers, axles, etc.
Power Source Located in Welding Cell (II)
-
-
-
-
-
-
-
-
-
Area of application:
For test systems only (no wirespool in series production)
Power Source Not Located in Welding Cell (I)
-
-
-
-
-
-
-
-
-
Area of application:
Robot axles 1–6 carry out the welding feed movements.
Example:
Longitudinal seams on boilers, battery trays, etc.
TPS 500i – power source
HP 95i CON W / 1.2 m / 95 mm² – interconnecting hosepack
SB 360i LaserHybrid – SplitBox, mounted on the power source
MHP 360i LH/W/FSC/FW 7.5m – LaserHybrid hosepack
Welding wire drum
WF 25i REEL 4R – wirefeeder reel
WF MOUNTING Drum
Wirefeeding hose L = 10 m
Laser welding head
TPS 500i – power source
HP 95i CON W / 1.2 m / 95 mm² – interconnecting hosepack
SB 360i LaserHybrid – SplitBox, mounted on the power source
MHP 360i LH/W/FSC/FW 7.5m – LaserHybrid hosepack
Wirespool
WF 25i REEL 4R – wirefeeder reel
WF reel carriage D300
Wirefeeding hose L = 10 m
Laser welding head
TPS 500i – power source
HP 95i CON W / 10 m / 95 mm² – interconnecting hosepack
SB 360i LaserHybrid – SplitBox, mounted on the robot or the wall
MHP 360i LH/W/FSC/FW 4.2m – LaserHybrid hosepack
Welding wire drum
WF 25i REEL 4R – wirefeeder reel
WF MOUNTING Drum
Wirefeeding hose L = 20 m
Laser welding head
25