Configure The Controller; Monitor The Actuator Switching Cycles; Reset The Maintenance Interval; Set The Canopen Communication Or The Büs Communication - Burkert 8756 Batch Operating Instructions Manual

The device waits the end of the balancing time to consider that the dosing is finished.
If the device detects a non-null flow rate after the set balancing time has elapsed, then the device gener-
ates an error event.
8.4.5

Configure the controller

Connect the device to the Bürkert Communicator software. Refer to
ator [} 38]
In the Bürkert Communicator software, select the device.
Go to Controller
The status indicator is orange.
A check-function event is generated.
Follow the instructions of the displayed wizard.
8.4.6

Monitor the actuator switching cycles

Is used to inform via message, that the actuator maintenance is required. Check for the quality of the dos-
ings.
Connect the device to the Bürkert Communicator software. Refer to
ator [} 38]
In the Bürkert Communicator software, select the device.
Go to Actuator
Activate the monitoring via
Choose your number of switching cycles until maintenance is required.
At this set number, the device will generate a maintenance message. Refer to error id 19 in
ID [} 42].
At 80% of this set number the device generates a warning message. Refer to error id 18 in
ID [} 42].
8.4.7

Reset the maintenance interval

To reset the maintenance interval, if a valve was replaced, do the following:
Connect the device to the Bürkert Communicator software. Refer to
ator [} 38]
In the Bürkert Communicator software, select the device.
Go to Actuator
It's also possible to postpone the maintenance message and acknowledge the Error-ID bit by selecting
Postpone maintenance
It's also possible to postpone the warning message by selecting
message and Error-ID bit. This has to be done after every restart of the device.
8.5 Set the CANopen communication or the büS
communication
büS / CANopen variant
To set the operating mode of the digital communication, do the following:
46
> Parameter > Choose Start-Up Wizard
> Diagnostics > Choose Switching cycles monitoring
enable monitoring
> Diagnostics > Switching cycles monitoring
interval. This has to be done after every restart of the device.
Connect to the Bürkert Communic-
Connect to the Bürkert Communic-
> Yes > Maintenance interval
Connect to the Bürkert Communic-
> Reset maintenance interval
Postpone warning
Type 8756 Batch
Configuration with Bürkert
Communicator
PDO3, Error
PDO3, Error
to acknowledge the