Changing Between Büs And Canopen Mode - Burkert 8756 Batch Operating Instructions Manual

The transmission speed of all the PDOs is increased.
To go back to the default transmission speed, click
switches to Set diagnostic
8.7 Changing between büS and CANopen mode
büS / CANopen variant
To choose between the different digital communication modes
communicator.
Connect the device to the Bürkert Communicator software. Refer to
ator [} 38]
Select the device.
Go to General settings
Choose the operating mode of the digital communication.
Restart the device.
The operating mode of the fieldbus is changed.
If the operating mode of the fieldbus is büS, the
are sent to büS.
If the operating mode of the fieldbus is CANopen, the
open network master switches the device to Operational.
48
mode.
> Parameter > büS > Advanced
CANopen status
Type 8756 Batch
Configuration with Bürkert
Communicator
Set to default values. The function
(büS or CANopen), use the software Bürkert
Connect to the Bürkert Communic-
> Bus mode
is set to Operational
CANopen status is set to
Inhibit time
and the PDO's
Pre-Op until the CAN-