Burkert 8756 Batch Operating Instructions Manual page 39

Type 8756 Batch
Configuration with Bürkert
Communicator
Choose the port Bürkert USB büS stick, click on
list of devices.
In the navigation area, click on the symbol related to the device: The device menu appears.
büS / CANopen variant
Use the USB-büS-Interface set with article number 00772426.
Fig. 12: USB-büS-Interface set
Download the latest version of the Type 8920 Bürkert Communicator from country.burkert.com.
Install the Bürkert Communicator on a PC. During installation, the büS stick must not be inserted at the
PC.
Fig. 13: Electrical connection parts of the USB-büS-Interface set
Insert the micro-USB plug into the büS stick.
Insert the appropriate power adapter into the AC/DC adapter.
Connect the jack male-connector of the AC/DC-adapter cable to the jack female-connector of the M12
female-connector cable.
Connect the M12 female connector to the büS network.
If the device is connected to a büS network and is at a büS end, then set the büS stick switch to "ON".
The termination resistance that is integrated in the büS stick is then activated.
Insert the büS stick into a USB port of the PC.
Wait until the Windows pilot of the büS stick has been completely installed on the PC.
Connect the AC/DC adapter to the power supply.
Start the Bürkert Communicator.
büS stick with termination-
resistance switch
micro-USB connector
jack female-connector
jack male-connector
Finish and wait until the device symbol appears in the
5-pin M12 female connector
AC/DC adapter
39