Maintenance; Replace The Memory Card; Replace The On/Off Valve Type 6013 - Burkert 8756 Batch Operating Instructions Manual

Type 8756 Batch

Maintenance

9 MAINTENANCE
If the device is operated according to the Operating instructions, then the device is maintenance-free.
Risk of injury or material damage when working on the device or system.
Read and observe the chapter
9.1

Replace the memory card

De-energise the device.
With a TX8 screwdriver loosen the screws of the cover. Remove the cover.
Fig. 14: Insertion direction of the memory card
Remove the old memory card from its slot.
Pay attention to the insertion direction of the memory card.
Fig. 15: Cross-sectional drawing
With a TX8 screwdriver, screw the cover to a torque of 1.2 N·m (0.9 lbf·ft).
Restart the device to write the data on the new memory card. Possible problems related to the memory
card are given in Troubleshooting [} 53]
büS / CANopen variant
The büS/CANopen variant supports the config-client if no memory card is used.
For detailed information, refer to the Operating Instructions "Central configuration management of Bürkert
devices" that can be downloaded from country.burkert.com.
9.2

Replace the on/off valve Type 6013

Prepare the device for the replacement of the on/off valve:
Flush the device.
Relieve the flushing fluid pressure in the installation.
Safety [} 8] before working on the device or system.
Screws
Cover
Memory card: make sure the
insertion direction is correct.
Inserted memory card
49