Set Binding With One Click; View Bindings - Ebyte E180-Z5812 Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
Set the binding source device and target device according to " Setting Node Constant Connection Binding (3.3.6) " in the "HEX
Command" manual . Note that the binding objects are all ports (virtual devices) on each node, that is, each port needs a unique SN
number composed of port number + MAC address.
Note: Each node has several virtual devices that can be used as binding objects.
Using the Ebyte PC tool, you can easily set the binding source and binding target. When configuring binding remotely, in
addition to operating on the coordinator, you can also operate on the router or end node. In addition, if the binding target SN is all 0, it
means that the binding target is yourself. This method allows the router or terminal node to serve as the master and allow other nodes
to bind to it, making it easier to obtain the other party's status.

5.3.2 Set binding with one click

This method can only bind transparent transmission targets and cannot report binding status.
After the router or terminal is configured with the network, input a 50ms~500ms low-level signal to the LINK button (PD4) to
trigger the button. Two routers or terminal modules trigger the LINK button one after another. The NET pin (PC1) of the module that
is triggered first outputs a high and low level of 1Hz, and the second module triggers the button.
One-key binding can also be triggered by using the HEX command " Automatically bind target (2.1.17) " or the AT command
"AT+FIND" instead of pressing a button.

5.3.3 View bindings

You can use the coordinator to view the binding of the node, and use the HEX command " View node constant connection
binding (3.3.8) " to view the binding table. By entering the node short address, you can see which virtual SNs of other devices are
bound to all virtual SNs under the node.
Using Ebyte PC software, you can also view other devices bound to each device.
Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
E180-Z5812 Series User Manual
23