Sensor Triggers Alarm - Ebyte E180-Z5812 Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
After adding the above attributes, save and reset and restart, then modify the attributes "Manufacturer Name", "Product Model",
and "Production Date". Just enter a valid string.
For security sensors, you need to edit the attribute "Security Sensor Type". According to the ZCL specification table, the
corresponding value of "Motion sensor" is 0x000D. Modify the attribute value and save it in FLASH.
Enter the read and write attribute command to modify the "Security Sensor Type"
55 0E 00 43 [02] [00] [00] [00 05] [00 00] [01 00] [0D 00] 48
The contents in "[ ]" are as follows
Operation mode = 0x02, write attributes and save FLASH

Port index = 0x00, the property being written is located on the first port created

Attribute direction = 0x00, the attribute being written is the server side

Cluster ID=0x0500, the attribute being written is located in cluster 0x0500

Manufacturer code = 0x0000, the attribute manufacturer code being written is 0x0000

Attribute ID=0x0001, the ID of the attribute being written is 0x0001

Written attribute value = 0x000D

Then reset the module and add the module to the gateway.

6.2.3 Sensor triggers alarm

Send ZCL control command:
55 15 02 0F [00] [00 00] [01] [75] [01] [00 05] [00 00] [00] [00] [01 00 00 FE 01 00] 83
The contents in "[ ]" are as follows
Send mode = 0x00, port index 0 sends command, no mode.

Target short address=0x0000

Destination port=0x01

Frame number=0x75

Command direction=Server->Client, this is a command sent from the controlled end to the control end, and the sensors are

all controlled ends.
Cluster ID=0x0500

Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
E180-Z5812 Series User Manual
34