Module As Ap To Establish Tcp Server Wireless Connection With Pc - Ebyte E103-W02 User Manual

Serial wifi smd small volume pcb antenna mqtt

Hide thumbs Also See for E103-W02:

Table of Contents

④ . We open the wireless network on the PC, find the wireless network with SSID starting with "EBT" (e.g.

EBT_9BB311), and click "Next" to connect. (Here "9BB311" is the last 6 bits of the module MAC address, different

modules have different MAC addresses, so different modules have different factory SSIDs)

⑤.

After successful connection, the LED1 on the module base board is always on (GPIO9 is pulled low) and the PC shows

successful connection, otherwise, please operate the above steps again.

3.1.2 Module as AP to establish TCP SERVER wireless connection with PC

①. Open the TCP&UDP test tool, create the connection and set the parameters (see the figure below). (The parameter

value can be queried by sending the corresponding AT command through the serial debugging assistant and then exit the

AT command mode to realize the subsequent bi-directional communication between the PC and the module)

Table of Contents