Hex Commands Supported By This Product - Ebyte E180-Z5812 Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
When the module sends network management commands and ZCL send commands by broadcast, due to the impact of broadcast
flooding, the send confirmation will be triggered 1 second after the feedback command. Therefore, it is recommended that the sending
interval be greater than 1 second when using this module for broadcast or multicast.

4.1.3 HEX commands supported by this product

EBYTE's full range of Zigbee products use unified HEX commands. However, due to differences in chip solutions and software
configurations, the actual HEX commands supported are different. This section shows the HEX command directory supported by this
product. For the format and content of HEX commands, please refer to "EBYTE" ZigBee3.0 module HEX command standard
specification》
Query the current status of the module
Start configuring network
Stop distribution network
Reset/factory restore
Set the local node type (terminal nodes
only)
Query and set up channels
View local group additions
Add local group
This machine leaves the group
Set and query the current transmit power
Read local properties
Set local properties
Automatically bind target
Read the network node address table
Retransmit
Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
Command name
local configuration class
device information
Command type command
code
0x00 0x00
0x00 0x02
0x00 0x03
0x00 0x04
0x00 0x05
0x00 0x06
0x00 0x09
0x00 0x0A
0x00 0x0B
0x00 0x0D
0x00 0x10
0x00 0x11
0x00 0x14
0x00 0x22
0x00 0x28
E180-Z5812 Series User Manual
12