Module Network Distribution And Data Transmission; Module Network Distribution; Hex Command Network Configuration; At Command Network Distribution - Ebyte E180-Z5812 Series User Manual

Tlsr8258 2.4ghz zigbee3.0 multi-function soc wireless module

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd.

5 Module Network Distribution and Data Transmission

Modules that are not configured with a network cannot transmit data, and modules that are configured with a network are always

in the network with a network, unless the network is removed.

When configuring the network, first let the coordinator configure the network. The newly shipped coordinator does not have a

network configured. Use the HEX command "Start Network Configuration ("HEX Command" 2.1.3)" and the coordinator will create a

new network. The coordinator will automatically generate a valid PANID to indicate that the network is successfully established, and

will open a channel to run the network. The coordinator continues to run on the network after restarting.

If routers, terminal nodes, and dormant terminals need to join the network, the coordinator needs to execute the "Start Network

Configuration" command again, indicating that the coordinator accepts new devices into the network. Routers, terminal nodes, and

dormant terminals that need to access the network also execute the "Start Network Configuration" command. After the network

configuration is completed, routers, terminal nodes, and dormant terminals will receive the "Network Status Change Notification"

command regardless of whether the network configuration is successful or not. The "Network Status Change Notification" command

will inform the host computer user whether the network configuration is successful. You can also use the "Query Module Current

Status" command to check whether the module has been configured for the network.

When the module is in transparent transmission mode, you can enable AT commands for network configuration. In transparent

transmission mode, enter the 3 characters "+AT" to enable AT mode.

When the coordinator is in AT mode, enter "AT+JOIN" to open the network. Enter "AT+JOIN" on the router and end node to

open the network.

Pin PD4 (network connection pin) inputs a low-level signal lasting 10ms~200ms to trigger the button function. The router or

terminal node actively connects to the coordinator when the network is not configured. The coordinator inputs the button signal on this

pin. Enter distribution network mode.

It is necessary to pay attention to the routers and terminal nodes that have been configured with the network. If multiple such

devices press the network configuration button at the same time, the binding mode will be triggered, that is, each other will be set as

the target device for transparent transmission of data.

Whether the data transmission module is in HEX command mode or data transparent transmission mode, the data transmission

E180-Z5812 Series User Manual

Table of Contents