Ebyte E180-Z5812 Series User Manual page 39

Chengdu Ebyte Electronic Technology Co., Ltd.
Manufacturer code=0x0000

Reply mode=0

Command ID=0x00

Command parameter=[01 00 00 FE 01 00]

Analyze the command parameters according to "Zigbee Cluster Library". The parameters of the security alarm command are as shown
in the table.
Command parameters:
[01 00] [00] [FE] [01 00]
The contents in "[ ]" are as follows
Alarm status = 0x0001. According to the sensor protocol specification, you also need to write the attribute "security alarm

status" to this value.
extended status=0x00

Defense zone ID=0xFE, this value also needs to be written simultaneously with the attribute "defense zone ID"

Alarm delay=0x0001, unit 250ms.

Attachment: Notes on sensor trigger control commands:
Sensors are mostly dormant terminals and have a high failure rate in sending commands. Each time the alarm command is

retransmitted, an "alarm delay" needs to be accumulated based on time.
The "alarm status" and "defense zone ID" in the alarm command need to be synchronized with the attributes "security

alarm status" and "defense zone ID" in the device. It is recommended that when the MCU detects an alarm during operation,
write these two attribute values first, and then Read these two attributes and send the alarm command regularly with a cycle
of 250ms. The timing will not stop until the alarm command is sent successfully.
Receive feedback command after issuing ZCL control command:
55 05 02 0F [00] 75 78
Send command is valid

Receive sending confirmation command:
55 0A 8F 02 [00] [00 00] [01] [75] [01] [00] F8
The contents in "[ ]" are as follows
Send mode = 0x00, port index 0 sends command, no mode.

Target short address=0x0000

Destination port=0x01

Frame number=0x75

Command direction=Server->Client, this is a command sent from the controlled end to the control end, and the sensors are

all controlled ends.
Sending result=0x00, sending successfully

Because the default return frame was not turned off when sending, the default return frame from the coordinator was also
received.
55 10 82 0B [20] [00 00] [01] [75] [00] [00 05] [00 00] [C8] [00] [00] 10
The contents in "[ ]" are as follows
Receive mode = 0x20, the received signal strength is valid, and the local port index 0 is port 0x02 that receives the

Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
E180-Z5812 Series User Manual
35