Introduction To Equipment Types; Coordinator - Ebyte E180-Z5812 Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
need for specially customized firmware.
Large capacity: 512K capacity flash, 64K capacity RAM, network nodes can be expanded to more than 100;

Role switching: Users can use serial port commands to switch the device between the two types of terminal and dormant

terminal (limited to terminal node version);
Supports multiple network topologies: point-to-point, star network, MESH network;

Network self-healing: If the intermediate node of the network is lost, other networks will automatically join or maintain the

original network;
Address search : Users can find the corresponding short address based on the MAC address of the node that has joined the

network, and can also find the corresponding long address of each node in the network based on the node's short address.
Network management: The coordinator version can manage the MAC addresses of all network nodes (routing nodes and

terminal nodes), and add and delete nodes freely.
Data security: Integrated ZIGBEE 3.0 secure communication standard, the network contains multi-level security keys;

Serial port configuration: The module has built-in serial port instructions. Users can configure (view) the parameters and

functions of the module through the serial port instructions.
Network PAN_ID change: Any switching of network PAN_ID, the user can customize the PAN_ID to join the

corresponding network or the PAN_ID will be automatically selected to join the network;
PWM control: local/remote PWM control, 4 PWM channels for user selection;

ADC control: local/remote ADC reading, 2 ADC channels for user selection;

One-click baud rate recovery: If the user forgets or does not know the baud rate, this function can be used to restore the

default baud rate to 115200.
Serial port reception wake-up: supports the serial port reception wake-up function. When the module is in sleep state, it

will wake up when it receives a frame of data less than or equal to 10 bytes. This data is a wake-up frame used to wake up
the module and will not be treated as data. .
Module reset: Users can reset the module through serial port commands.

Restore factory settings: Users can restore the module to factory settings through serial port commands.

Remote management and remote configuration: Users can use ZCL commands to remotely manage and remotely configure

other devices in the network

1.3 Introduction to equipment types

There are four logical device types in the ZigBee network: Coordinator (coordinator), Router (router), End-Device
(non-sleep terminal) and Sleep-End-Device (sleep terminal). The ZigBee network consists of a Coordinator, multiple Routers and
multiple End_Devices (the end nodes can be divided into dormant terminals and non-dormant terminals). This product has three
forms, namely dedicated coordinator, dedicated router and dedicated terminal node. The dedicated terminal node supports two
device types: End-Device (non-sleep terminal) and Sleep-End-Device (sleep terminal).
Note: The E180-Z5812 series only supports routers and terminals. E180-Z5812 SP and E180-Z5812 SX are terminal
modules, and E180-Z5812 SP-R and E180-Z5812 SX-R are router modules.

1.3.1 Coordinator

It has the function of establishing and managing the network, controls whether other nodes are allowed to join the network,
stores network information, and has all the functions of a routing device. Its main tasks are to manage the network, record sub-node
information, and forward messages. At the same time, the coordinator It is necessary to authenticate the terminal permissions
requesting network access.
Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
E180-Z5812 Series User Manual
2