Ebyte E180-Z5812 Series User Manual page 11

Chengdu Ebyte Electronic Technology Co., Ltd.
8 NC
9 PD4(LINK)
10 PA1( BAUD_
R )
11 PB1(LED1)
12 PC0(GPIO0)
13 VCC
14 GND
15 PB4(GPIO1)
16 NC
17 NC
18 PB5(AUX)
19 NC
20 NC
twenty one PB6(ADC1)
twenty two PB7(ADC2)
twenty three NC
twenty four NC
25 SWCLK
26 SWDIO
27 PC2(PWM0)
28 PC3(PWM1)
29 PC4(PWM2)
30 PC1(NET)
31 NC
32 PD2(PWM3)
33 NC
34 NC
35 NC
36 GND
37 nRESET
Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
- Reserved, left empty
enter Network connection pin.
enter The UART_ BAUD _RESET pin is used to reset the device baud rate. It
defaults to high level when powered on. In any mode, if this pin is pulled low
for more than 1000ms, the module serial port parameters will return to the
default 115200.
output Reserved LED indication
input Output GPIO input/output port 0
- Module power supply positive reference voltage, voltage range
- Ground wire, connected to the power reference ground
input Output GPIO input/output port 1
- Reserved, left empty
- Reserved, left empty
output The AUX pin indicates the current working status of the device. When the pin
is low, it indicates that the device is busy. When the pin is high, it indicates that
the device is idle.
- Reserved, left empty
- Reserved, left empty
enter ADC detection port 1
enter ADC detection port 2
- Reserved, left empty
- Reserved, left empty
input Output Serial debug interface, serial line clock
input Output Serial debugging interface, serial data input and output
output PWM output port 0
output PWM output port 1
output PWM output port 2
output The NET pin indicates the current network status of the module. Flashing
indicates that the network is being configured or bound.
- Reserved, left empty
output PWM output port 3
- Reserved, left empty
- Reserved, left empty
- Reserved, left empty
input Output Ground wire, connected to the power reference ground
enter reset pin
E180-Z5812 Series User Manual
7