Ebyte E180-Z5812 Series User Manual page 13

Chengdu Ebyte Electronic Technology Co., Ltd.
12 P C0 (GPIO0)
13 VCC
14 GND
15 P B4 (GPIO1)
16 NC
17 NC
18 P B5(AUX)
19 NC
20 NC
twenty one P B 6 (ADC1)
twenty two P B 7 (ADC2)
twenty three NC
twenty four NC
25 SWCLK
26 SW DIO
27 P C2 (PWM0)
28 P C3 (PWM2)
29 P C
(PWM3)
30 PC1 (LINK)
31 NC
32 P D2 (PWM1)
33 NC
34 NC
35 NC
36 GND
37 n RESET
Copyright © 2012–2024 , Chengdu Ebyte Electronic Technology Co., Ltd.
successful, the pin is pulled high.
input Output GPIO input/output port 0
- Module power supply positive reference voltage, voltage range
- Ground wire, connected to the power reference ground
input Output GPIO input/output port 1
- Reserved, left empty
- Reserved, left empty
output The AUX pin indicates the current working status of the device. When the pin
is low, it indicates that the device is busy. When the pin is high, it indicates that
the device is idle.
- Reserved, left empty
- Reserved, left empty
enter ADC detection port 1
enter ADC detection port 2
- Reserved, left empty
- Reserved, left empty
input Output Serial debug interface, serial line clock
input Output Serial debugging interface, serial data input and output
output PWM output port 0
output PWM output port 2
4 output PWM output port 3
output The LINK pin indicates the current network status of the module, and the
output high level meter has been added to the network.
- Reserved, left empty
output PWM output port 1
- Reserved, left empty
- Reserved, left empty
- Reserved, left empty
input Output Ground wire, connected to the power reference ground
enter reset pin
E180-Z5812 Series User Manual
9