Maintenance Output Setting; Sensor Cap Output Setting - Optex DOS-20 Instruction Manual

Maintenance output setting

Set a maintenance timer for any cycle ("Maintenance timer" P.42) to notify
the user when the set period has elapsed.
Use this for notification of sensor maintenance, replacement of
consumables, and overhaul timing.
Check notifications by the relay output and dedicated cloud server (SC-U1
and GW connected).
For more information about checking notifications on the cloud server, refer
to the cloud server's help.
For operation, refer to the "Universal Transmitter SC-U1 Operation
Manual", "5.4 Relay Setting" and " ◆ Maintenance output setting".

Sensor cap output setting

Set notification of sensor cap replacement timing.
If the sensor cap replacement timer is set to OFF, refer to "Sensor
cap replacement timer" P.43 and set the output cycle (days)
Caution
before making the following settings.
After the setting, the sensor cap output is available as a relay
output item.
Press
1
The sensor selection display is displayed.
Select [Relay Setting] using
2
18
.
, and press .