Attaching The Sensor Cap - Optex DOS-20 Instruction Manual

3

Attaching the Sensor Cap

Rotate the protective cover and remove it from the sensor,
1
and then remove the red protective cap.
Caution
Remove the sensor cap supplied from the storage case.
2
Align the arrows on the sensor cap and
3
the sensor, push the sensor cap straight
onto it and then press it into place while
making sure there are no gaps.
Reattach the protective cover.
4
・ Before reattaching the cover, check to make sure the O-ring on
the sensor has not become detached from the torsion or groove.
・ Remove the sensor cap from the vacuum pack just before
attaching it, and then attach it as soon as possible.
・ Make sure that the sensor cap is attached so that dust or
moisture is unable to enter.
Caution
Failure to observe this may result in incorrect measurements.
・ The date of manufacture is listed at
the location indicated by the illustration
on the sensor cap storage container.
8
Protective cap
Store the protective cap for later use.
Protective cover