Table of Contents
Advertisement
Installation of End of Bale Sensor
The bale rate timer/ end of bale sensor is used to determine when the baler door is open upon bale
completion. With this information the system is able to change the tons/hour automatically (see Operating
Instructions, Automatic Mode).
Locate the sensor (006-7401) and the sensor bracket (001-4648RB). On the right side of the baler find a
location 1"– 6" down from the pivot point, in a well-suited place, to mount the bracket. Check for clearance with
hydraulic cylinders before mounting the bracket. The bracket should be mounted to the front side of the hinge
point, with the sensor aligned over the back door.
Mark and drill two 1/4" (7mm) holes and install the bracket using two 5/16" x1/4" self-tapping bolts.
Install the sensor into the bracket and leave 1/4" (7mm) of clearance between the end of the sensor and the
door.
The harness will need to be routed towards the Processor. Secure with cable ties and take care to avoid pinch
points. The harness extension (006-7401EXT) may need to be used.
Hinge Point
Back Door
*Additional parts and harness extensions have been included to allow you to
easily disconnect the baler unit from the power unit, use as needed.
View of the right side of
baler
9
006-7401
001-4648RB
Front of baler
Advertisement
Table of Contents
