Table of Contents
Advertisement
Installation of Applicator
Installation of Mounting Brackets and Tank
1. Locate parts 001-4703ZR-A, 001-4703ZR-B, two 001-4703ZR-C and four ¾" x 4 ½" bolts, lock
washers and nut.
2. Line up 001-4703ZR-A and 001-4703ZR-B about 18 inches apart on the ground. Slide part
001-4703ZR-C into square mounts and secure with ¾" x 4 ½" bolts, locks, and nuts to holed in
place. Note there are two sets of ¾" holes on the 001-4703ZR-C. Use the set that is about 18
inches apart.
3. Locate part 001-4703ZR-D1 and two ½" x 5 ½" bolts, locks, washers, and nuts. Bolt part 001-
4703ZR-D1 to the top of the two 001-4703ZR-C with this hardware.
4. Locate part 001-4703ZR-D2. Bolt to the front of 001-4703ZR-D1 with ½" x 3 ½" bolts,
washers, locks, and nuts. Do not fully tighten down.
5. Using a lift, bring the assembly up under the cab of the baler. Part 001-4703ZR-D2 should line
up with holes in the front part of the baler. Mark the half inch holes at the ends of the 001-
4703ZR-A and 001-4703ZR-B that line up with the structural parts under the cab. Lower
assembly out of the way and drill these four holes with a 9/16" drill bit. (Note. Do not drill into
hydraulic lines or electrical wires.
6. Once holes have been drilled. Lift assembly back up under cab and attach to baler with four
½" x 3 ½" bolts, washers on both sides, locks, and nuts. ¾" hardware is provided if you would
want to use this. However, part 001-4703ZR-A and 001-4703ZR-B will need to be drilled out
for the ¾" bolts. The 001-4703ZR-D2 will attach to the front mount with ½" x 2" bolts, washers
on both sides, locks, and nut.
7. Attach two 001-4703ZR-E to each 001-4703ZR-C (one on each side) sticking out the front of
the baler. Use ¾" x 4 ½" bolts, locks, nuts. Do not fully tighten down yet.
8. Attach 001-4703ZR-G to the 001-4703ZR-E at the height you desire to keep the tank about the
windrow. Note the lower the take the closer it is to the windrow coming into the baler. The
higher it will obstruct your view. Use ¾" x 4 ½" bolts, locks, and nuts to secure.
9. Attach 001-4703ZR-G to 001-4703ZR-F with ½" x 4" Bolts, washers, locks, and nut. Do not
fully tighten down. (Note: angles will be pointing toward each other.
10. Place saddle assembly on 001-4703ZR-G and secure with ½" washer, locks, and nuts.
11. Tighten all hardware down.
001-4703ZR-C
001-4703ZR-G
001-4703ZR-F
001-4703ZR-D2
4
001-4703ZR-A
001-4703ZR-D1
001-4703ZR-E
001-4703ZR-B
Advertisement
Table of Contents
