Optional Ipad Display Kit - Harvest TEC 735Z Installation Manual

55 gallon automatic preservative applicator

Hide thumbs

Table Of Contents

Table of Contents

Ref

Description

iPad Mini 4 (Refurbished)

Suction Cup Mount

Ram Mount

Spring Load Cradle

iPad Mini 4 Case

Lightning Comm. Cable

Power Harness

4 amp Fuse

Female Spade Connector

Eye Loop Connector

iPad Mini Charger 12V

12V Power Harness Installation Instructions (included with Mounting Kit Only)

1. Identify 12V power source for wires to connect.

2. Eye loops installed on harness if wiring directly to the battery is desired.

3. Test for key power source if preferred to have power to the USB shut off with the key.

4. Once power source is identified, cut wires to desired length if needed for key power connection.

5. Harness comes with quick connectors the white and black wires.

6. Remove the round locking plastic nut from USB plug before connecting the wires. Black (+) White (-).

7. The wires will then be hooked to the designated terminals on the bottom of the USB plug

8. Drill a 1 1/8" hole in the preferred mounting location. Be sure to clean any sharp edges after drilling.

9. Feed the wires through the mounting hole.

10. If using the round plastic nut to secure plug in place, slide the nut back over the wiring before connecting

the wires to powered source.

11. Connect the wires to the identified power source if easier to do so before tightening the plug into place.

12. Tighten plug using either the round plastic nut or mounting plate and two screws, both options supplied.

13. Once connected, hook a USB charging cord into the plug and connect a mobile device/tablet to ensure

the plug is operating as you wish (key power working properly if necessary).

NOTE: This plug is not designed to charge two iPads. System damage could occur if this is attempted.

System will charge a mobile phone and iPad simultaneously without problem.

*iPad mini is a trademark of Apple Inc., registered in the U.S. and other countries.