Table of Contents
Advertisement
Tractor Setup
The general tractor setup of the 700 Series applicator can be seen above. The main harness of interest is the
tractor power/communication harness (006-765IC). This harness will connect at the tractor battery, to the ISO
Communication Module (ICM) mounted in the cab, a keyed power connection point, and connect at the hitch
area to the baler power/communication harness (006-765B). View below to see highlighted installation
instruction:
12V Battery Connection
ISO Communication Module
Key Power Connection
Harness Connection to Baler
The 12V battery connection must be at the tractor battery. Connection to
alternative locations such as an accessory port can cause problems with
applicator system.
*MUST BE CONNECTED DIRECT TO TRACTOR BATTERY TERMINALS*
The ISO communication module is to be mounted inside the cab. Other
mounting locations can lead to issues with weathering and operation.
Once installed and the system is powered, a green light will turn on with
the ICM module.
Ensure a solid keyed connection is found inside the cab and wired into.
Poor keyed power connection can result in applicator system issues.
The tractor harness connects at the hitch to baler power/communication
harness (006-765B). This will allow the system components to
communicate with one another. Ensure connections are debris and
corrosion free.
10
Advertisement
Table of Contents
