Table of Contents
Advertisement
To set the test parameters, by recalling a Front Panel from the 7400, proceed as follows:
1.
Follow steps 1 to 4 listed above.
2.
Select the front panel set-up to be set from the 7 400.
3.
Press the Digital Interface "Input" key.
4.
Locate the file to be used (refer to the 7400 Instruction Manual).
5.
Press the Read File/Block "One F/S" key. The selected front panel of the 1050 will
be set to the recorded values.
4.2.5. Graphics Recorder Type 2313
32
Fig. 4.5. Graphics Recorder Type 2313
Graphics Recorder Type 2313 can be used to print out a list of the test set-up parame-
ters, together with their set values. It can print out sets of the dynamic parameters:
frequency, generator level (actual) and vibration meter level.
To print out the dynamic parameters, during a test, proceed as follows:
1.
Connect the Interface Bus (IEEE-488) of the 1 050 to the Interface Bus (IEC-625) of
the 2313 using cable AO 0264.
2.
Set the 2313 Address Switch 6 to "0: System Controller not active".
3.
Press the 2313 Reset key, the Entering LED will light.
4.
Press the 2313 Exc./Ent key, the Listen LED wil! light.
5.
Initiate the read-out using the procedure given in section 4.2.2, steps 4 or 5. This
choice depends on whether a synchronized read-out is required or not.
6.
To terminate a print-out, press Digital "Interface Output" for a second time.
Advertisement
Table of Contents
