Set_Level_ ( N); Set_Request_Enable - BRUEL & KJAER 1050 Instruction Manual

5.4.56. Set_Level_ ( N)
Sets the level and function of a selected Vibration Meter Set Level as in the front panel
functions Vibration Meter "Set Levels" and "Function" with the rear panel Input Sensi-
tivity switch set to "Unit I ms-
2
".
Example of Use:
Set_Level_ < N) <Function) , <Numeric) , <Unit) - General Syntax, see Notes
Set_Leve1_5 Acceleration , 1 . 5
Set_Leve1_7 Velocity, 7. 21
Set_Leve1_2 Displacement , 3 . 74
Notes:
- Sets vibration level 7 to 1,5
current acceleration units
(m/s
2
or g)
- Sets vibration level 7 to 7,21
current velocity units (m/s or
in/s)
- Sets vibration level 2 to 3,7 4
current displacement units
(mm or in)
In the 'General Syntax', 'N' is the vibration level number (1 to 9), 'Function' is Accelera-
tion, Velocity or Displacement, and 'Numeric' is the desired level.
The 'Unit' may be omitted. If Newtons are displayed, lbf may be specified and vice
versa. In this case the current unit will be maintained but the entered 'Numeric' value will
be converted to fit the current unit.
5.4.57. Set_Level_
<
N)?
Enables read out of the contents of a selected Vibration Meter Set Level.
Example of Use:
Set_Leve1_5?
enables read out of:
S_L_S A , 1 . SOE +OOm/s/s
- If set using the example in section 5.4.56 and if
Sl units are active, see section 5.4.43
5.4.58. Set_Request_Enable
58
Sets the conditions for the 1 050 to send a Service Request (SRQ).
Example of Use:
Set_Request_Enable NONe - Default - SRQ's from 1050 will be disabled
Set_Request_Enable Srq_Switch - Will send an SRQ when the Digital Interface
"SRQ/ Addr." switch is activated
Set_Request_Enable Sweep_End - Will send an SRQ on completing the set
number of sweeps
Set_Request_Enable Data_Ready - Will send an SRQ when data is ready to be
read out of the 1 050