BRUEL & KJAER 1050 Instruction Manual page 64

56
Example of Use:
Readout_ Type SINgle , <Mode)
General syntax for specifying a single read out
Readout_ Type SINgle , 1
Specifies a single read out of frequency (mode 1 - see Notes)
Readout_ Type Continuous , <Interval) , <Mode)
General Syntax for specifying a continuous read out
Readout_ Type Continuous , 2 . 5 , 5
Specifies continuous read out of frequency and meter level (mode 5 - see Notes), with
2,5 second intervals between read outs.
Readout_ Type Start_ On_ Sweep , <Interval) , <Mode)
General syntax for specifying continuous read out, activated when the sweep is started
Readout_ Type Start_On_Sweep , 1 . 25 , 6
Specifies continuous read out, activated when the sweep is started, of the Frequency,
Generator Level and Meter Level, with 1 ,25 second intervals between read outs
Notes:
If the parameter Start_On_Sweep is used, the read out will commence once the sweep is
activated and the Start_On_Sweep parameter will phange to 'Continuous' read out.
The 'Interval' will be the interval between read-outs, entered in seconds. The range is 0,1
to 100 seconds in 0,01 s steps. When single read out is chosen, the 'Interval' parameter
must be omitted.
The 'Mode' will be a number from 1 to 6 corresponding to the interface Message(s)
listed in Table 5.3.
For continuous read-outs, the Sweep Count will be read out together with the parame-
ters specified by the 'Mode' the first time, and each time the Sweep Count elapsed has
been increased.
Mode
Job Header Section
1 Frequency
5.4.7
2 Generator _Levei_Actual
5.4.11
3
Meter _Level
5.4.29
4
Frequency, Generator _Levei_Actual
5
Frequency, Meter _Level
6
Frequency, Generator _Levei_Actual, Meter _Level
T01145GBO
Table 5.3. Interface Messages corresponding to the 'Mode' number
of the Readout_ Type interface Message