BRUEL & KJAER 1050 Instruction Manual page 78

Error No. Description
64 Error at argument for: Compressor
66
Error at argument for: Readout_ Type
67 Error at argument for: Set_Request_Enable
68 Error at argument for: Error _Stop
69 Error at argument for: Auto_Range
70 Error at argument for: Identify
71
Error at argument for: Error
72 Error at argument for: Cross_ Over _Calculate
73 Error at argument for: Front_Panei_Select
74 Error at argument for: Front_Panei_Enable
75 Error at argument for: Readout_lnitiate
76 Error at argument for: Readout_ TErminate
77 Error at argument for: Output_Header
78
Error at argument for: Charge_Sensitivity_Correction
80
One or more samples in a Continuous readout are lost due to slow receiver
81 Readout interval too short (adjusted to limiting value)
82 Readout interval too long (adjusted to limiting value)
83 Readout_ TErminate received but no Continuous readout is running
84 Continuous readout stopped irregularily
85
IEEE job interrupted before finish
100 Non-volatile memories have changed during power off, therefore set to default values
101-109 Consistence error at Cross-over Frequency N (N
=
1 ... 9)
111-119 Test set-up error at Set Level N (N
=
1 ... 9)
. 121-128 Cross-over Calculation error at Cross-over Frequency N (N
=
1 ... 8)
130 Compressor Lower Safety Limit violated during operation
131 Compressor Upper Safety Limit violated during operation
132 Sweep time too short
140 Control of Auxiliary apparatus no longer functions
141
Control of Auxiliary apparatus is bad functioning
150
Transition to Stand-by has disabled the enabled Device Trigger
151
Device Trigger received, but 1050 was not enabled to be triggered
152
The attempted Reset 1 to 5 is not allowed (Operate, LLO or Disabled)
T01098GBO
Table 7.2. Error Messages
70