Readout_Lnitiate; Readout_ Terminate; Readout_ Type - BRUEL & KJAER 1050 Instruction Manual

5.4.50. Readout_lnitiate
Enables read out of the data specified in the Readout_ Type interface Message (except
Start_On_Sweep), section 5.4.52.
Example of Use:
Readout_lnitiate
enables read out of, e.g.:
FREQ 4139. 784Hz
- For a frequency of 4139,784 Hz, if set as the first
example in section 5.4.52.
FREQ 1575 . 593Hz ; M_L 10 . 1 E +OOg ; S_C 0002 , 0000
FREQ 1749. 047Hz; M_L 10. 2E+00g
FREQ 1940. 850Hz; M_L 10. 2E+00g
FREQ 2153. 329Hz; M_L 10. 2E+00g
etc
Using the second example in section 5.4.52.
Notes:
See Notes in section 5.4.52.
An additional Sweep_Count? data (see section 5.4.65) will be read out each time the
Sweep Count Total-Elapsed number changes.
5.4.51. Readout_ Terminate
Terminates a continuous read out of data initiated by the Readout_lnitiate interface Mes-
sage (section 5.4.50).
Example of Use:
Readout_ TErminate
5.4.52. Readout_ Type
To
1050
Specifies the form of data read out when a read-out is initiated by using the Readout_ln-
itiate interface Message, section 5.4.50 (or by starting the sweep).
READOUT_ TYPE
Time Interval
in seconds
see text
Mode
(1 to 6)
Fig. 5.4. Syntax diagram for the Readout_ Type interface message
Table 5.3
861328
55