Setup; Sweep - BRUEL & KJAER 1050 Instruction Manual

5.4.60. Setup
5.4.61. Setup?
5.4.62. Sweep
60
Copies the settings of a selected front panel number into the current front panel number
or sets the current front panel settings to default values.
Example of Use:
Setup DEfault
Setup 2
Gives the setup status of the 1 050.
Example of Use:
Setup?
or
Setup? NUmber
enables read out of:
SETUP Number , (Data)
Setup? ACTive
Setup? ALl
Notes:
- Changes the current front panel settings to de-
fault values
- Copies the contents of front panel setting no. 2
into the current front panel no.
- Where 'Data' is 1 to 4.
- Enables read out of the active settings.
- Enables read out of all the front panel settings.
The front panel settings read out are individually selectable. Each setting is preceded by
the relevant shortened Message header.
A number of parameters in the whole front panel setup are often of no interest, e.g.
unused Set Levels, unused Cross Over Frequencies, and control parameters for non
present peripheral equipment. When SETUP? ACTUAL is used, these parameters are
automatically omitted from the read-out. When SETUP? ALL is used, they are all includ-
ed in the read-out.
Controls the frequency sweep as in the front panel Sweep Control "Stop", "Down" and
"Up" functions.
Example of Use:
SWeep Up
or
SWeep Up_ Trigger
or
SWeep DOwn
- Activates the Sweep Control "Up" function
- Enables Sweep Control "Up" to be initiated by
GET
- Activates the Sweep Control "Down" function